Plunger pump for the m10.

Plunger pump for the m10.

Units Electric Dosage Plunger -free -free M10 series are designed for voluminous pressure dosing of neutral and aggressive liquids, emulsions, suspensions.

Dose fluids have the following parameters: have the following parameters:

">

When installing units, you must provide a positive The pressure difference between the output and the entrance to the pump is at least 0.5 kgf/cm. Absolute pressure at the entrance to the pump should exceed the pressure of the saturated vapors of the dosed environment at an operating temperature by 0.6-0.7 kgf/cm.

The main parametric series of units with power drive up to 5.5 kW is given in table. 1. The maximum feed is indicated in the brackets (depending on the properties of the dosed fluid).

table 1.

kinematic viscosity, m2/s (St) 3.5x10 -7 ... 8x10 -3 (0,0035 ... 80)
The concentration of a solid non-abrasive phase, not More, % 30 < /span>
% of the diameter of the unit pipe, no more. 3 < /span>


drive power, kW
1.5 2.2 3.0 4,0 4,0 5.5
The maximum length of the plunger (according to scale), mm

16 < /span>
32 < /span> 		40 < /span>
maximum pressure, kgf/cm2
10 (12) 100 < /span> 100 < /span>
16 (20) 100 < /span> 100 < /span> 100 < /span>
25 (30) 100 < /span> 100 < /span> 100 < /span>
40 (50)

Write a review

Note: HTML is not translated!
   
Bad           Good
0 reviews / Write a review