Centrifugal horizontal pumps with a semi -spiral supply of liquid to the working wheel. The pump housing has a connector in a horizontal plane passing through the rotor axis. The absorbing and pressure pipes are cast by one whole with the pump body, located in its lower part and directed in opposite directions. This location of the pipes and the horizontal connector of the housing provide the ability to open, inspection, repair, replacement of the rotor or individual parts without dismantling pipelines and electric motor. Arial, Helvetica, Sans-Serif; Font-Size: 13px; Text-align: Justify; " />
The hull cover continues the configuration of the housing channels. In the upper part of the cover cover there is a hole for connecting a vacuumon or a filling device.
The pump shaft rotates in two bearing supports. The bearings are protected by jacking rings that discard fluid flowing through the shaft.
The density of the working cavity of the pump on the shaft is provided with a soft oil seal. Size: 13px; Text-align: Justify; " />
In the flanges of the pipes, holes are provided for the removal of liquid to the manometer and manovacumometer. In the lower part of the case there are two holes for the removal of the liquid during a long stop of the pump.
The pump drive is carried out through the connecting sleeve-jacket coupling. The direction of rotation of the shaft counterclockwise, if you look from the drive side.
The direction of rotation of the shaft is indicated by the arrow cast on the pump cover.
Scope
-designed for pumping water and other clean liquids
| Submission | 75 m3/h |
| Pressure | 115 m |
| Working temperature | up to + 85 ° C |
|
Pump 2 TS 75-115 , Where 2 - two -stage; TS - technological for sugar industry; 75 - feed, m3/h; 115 - pressure, m |
|
| Pumps | |
| Power/speed | 37/3000 |
| Flow, cubic meters/hour | 75 |
| pressure | 112 |
