The installation of the pump UNNTR 30/160 is designed to pump clean and contaminated fluid with a content of up to 5 % of mechanical impurities (up to 6 mm) at a temperature of up to 30 prices. Installation can be used in irrigation and irrigation systems in agriculture, as well as for pumping water from pits, trenches and other reservoirs.
The installation is mounted on the rear hinging device of the “Belarus” or DT-75 tractor, etc. The rotation of the installation pumps is made from the power selection shaft (VOM) of the tractor.
General information
The installation should work with a static position of the tractor. The water is made from the height of the absorption collector above the surface of the reservoir no more than 4m (in the mountains) and no more than 6m (on the plain) to reduce the supply (if desired) of the consumer or when one of the pumps fails, installation with one pump is possible. To do this, you need to remove both collectors, remove one of the pumps from the frame
And one coupling. Combine the pressure and absorption sleeves directly to the flanges of the remaining pump.
Technical characteristics
|
Feed, m3/hour |
30 |
|
Ples, m |
160 |
|
Installation power, kW |
30 |
|
Rotation frequency of VOM, rpm |
540 |
|
The speed of rotation of the pump shaft, rpm |
1350 |
|
Permissible absorption height, m |
6 |
