Conditions
Irtysh-TsNK1 125/200.224-110/2-400
Irtysh- a series of pumps
TsNK-centrifugal console pump with a general-industrial engine
125- nominal diameter of the working wheel
200- Conditional diameter of the working wheel
224- The actual diameter of the working wheel
110- The nominal power of the electric motor, kW
2- Two-pole electric motor, 2900ob/min
4- horizontal, on a stove with a connecting coupling
0- without a control panel
0- without protection
Application
water supply, supply of cold and hot water without abrasive substances in heating systems, cold and cooling water installations, as well as for irrigation and fire extinguishing installations.
When using additives, such as glycol or oil, you should check the suitability of the seal and the need to change the power (when the glycol is added from 10% of the volumetric part).
Technical data
Permissible pumped media:
- Water of heating systems
- Technical. Water - cooling./Cold water
- Water Glycol mixes
- Other environments on request
characteristics
- The number of revolutions is 1450, 2900 rpm
- Defense degree - IP 44
- Climate execution- at
- Placement category- 3
- Nominal diameter DY 32-150
- Temperature range from -10 ° C to +110 ° C (indicate the pr request)
- The maximum allowable ambient temperature is +40 ° C
- Other parameters on request
- Electrics 3-380 V, 50 Hz
- Motor protection is required additional (upon request)
- Watering of the motor isolation class F
- Standard electric motor.
- Explosion protection on request
Materials
Working Wheel, the case of pumping cast iron
Val-steel 45
Tips seal - silicon carbide/graphite
Design
Electro-axial unit from the pump and engine, mounted on a common foundation plate. The pump’s drive is carried out through an elastic coupling.
Pump building
The spiral case of a gray cast iron pump has paws, which is attached to the foundation plate. ANSTRUCTIONAL FLANTS RU = 16 kgf cm³ in accordance with GOST 12820-80 (for DU = 200 RU = 10 kgf cm³ according to GOST 12820-80).
Closed multi -channel wheel - a closed working wheel of gray cast iron
Thin seal - serial performance. Unsuitable, independent of the direction of rotation, end seal (salted seal on request)
Installation
Irtysh-TsNC console pumps are supplied completed by the foundation frame with an electric motor, a coupling and a protective casing).
Installation of the pump on the foundation
The proper manufacture of the foundation unit for the pump also affects the low -noise operation of the pump. To increase the perceiving vibration and compensation for the unbalanced forces, a direct strict connection of the pump unit and the foundation block is recommended. However, to extinguish vibration, the simultaneous insulation of the foundation block from the building of the building is necessary.
The external dimensions (length and width) of the foundation block should be 15-20 cm larger than the external dimensions of the foundation plate of the pump unit.
