Conditions
Irtysh - CML 50/200 - 1.1/4
Irtysh - a series of pumps
CML - centrifugal monoblock linear pump
1 - option of cutting the working wheel
32 - conditional passage of the pressure pipe
125 - nominal diameter of the working wheel
1.5 - nominal power of the electric motor
Application
The supply of cold and hot water without abrasive substances in heating systems, cold and cooling water installations, as well as for irrigation.
When using additives, such as glycol or oil, you should check the suitability of the seal and the need to change the power (when the glycol is added from 10% of the volumetric part).
Technical data
Permissible pumped media:
-
Water of heating systems
-
Technical water (cooling, cold)
-
Water Glycol mixes
-
Other environments- on request
Descriptions:
-
The number of revolutions is 1450.2900 1/min
-
Defense degree - IP 44
-
Climate execution- at
-
Placement category- 3
-
Nominal diameter DY 40-200
-
Temperature range from -10 ° C to +140 ° C (indicate the pr request)
-
The working pressure of Max. 16 BAR to 120 °
- Water of heating systems
- Technical water (cooling, cold)
- Water Glycol mixes
- Other environments- on request
Descriptions:
-
The number of revolutions is 1450.2900 1/min
-
Defense degree - IP 44
-
Climate execution- at
-
Placement category- 3
-
Nominal diameter DY 40-200
-
Temperature range from -10 ° C to +140 ° C (indicate the pr request)
-
The working pressure of Max. 16 BAR to 120 °
13 BAR to 140 °
- The maximum allowable ambient temperature is +40 ° C
Installation directly on the pipeline, connection to the pipeline and pressure sensors, a flange with a withdrawal to the pressure sensor
Motor protection is carried out by the customer or on request
Materials:
The pump body, delivery - gray cast iron
Working wheel - gray cast iron or synthetic material
Design
Single -stage circulation pump of low pressure, compact performance, for modern buildings equipment.
Pump building
The spiral housing of linear execution (input and output pipes with the same flanges are located on the same line). Flanges with the withdrawal to the pressure sensor.
Working wheel
Closed working wheel of synthetic material. From gray cast iron, - starting from the nominal diameter of the wheel 189mm.
Fabel seal
Serial design, undergoing end seal is used at water temperature up to 140 ° C; For any direction of rotation, the permissible content of glycol is up to 40% of the volumetric part.
Installation
Installation in position is not allowed by the engine. Any other situation is acceptable.
Block pumps should be installed on a solid foundation on the console.
When installing pumps with a capacity of more than 4 kW, it is necessary to use the corresponding lifting mechanism.
