design features
• the SPL series is designed to print non-abrasive large solid particles.
• the working wheel material-a non-fiberglass nyril.
• Steps with a vertical axis are closed working wheels.
• balancing holes in the working wheels provide minimal axial loads and dynamic balancing.
• the heat-resistant cylindrical roller bearing is used at both ends of the pump.
• the exhaust flange is on the engine side, and the absorption flange is down.
• provides a lesser savings for a horizontal shaft with a stop form.
• a quiet operation.
• they can be made from 1, 2, 3 or more pumps as necessary. < /div>
• they can be made with a three-phase engine.
• Singling booster installations with the protection of the phase and relay of the sequence (FKS), electric float (float).
• Equal aging (rotation).
• booster sets are ready for assembly with an expansion tank, a set of joints and a control panel. < /div>
areas of application
• Budbing systems
• household water supply systems
• agricultural irrigation
• industries
• structures
• schools
• hotels
• Consumption: up to 153 m³/hour < < /div>
• pressure: 150 m
• speed: up to 2900 rpm < < /div>
• fluid temperature: 10 ° C to + 60 ° C
• Body pressure (PMAX): 16 bar
